Suction is where the Qrevo S Pro pulls ahead, with 18,500 Pa against 8,000 Pa, plus a hotter mop wash at 167 °F and bigger dock tanks. The X10 Pro Omni counters with an RGB camera and LED light for obstacle spotting, mapping across up to 5 floors, and slightly higher mop pressure. Go with the eufy if dodging cords, socks, and pet toys matters most; go with the Roborock if deep carpet pickup and a lower-maintenance dock top your list.
Both of these robots run dual spinning mop pads, LiDAR mapping, and auto-emptying docks, so the decision comes down to two very different bets. eufy spent its engineering budget on seeing the floor: an RGB camera plus an LED light so the X10 Pro Omni can identify and steer around clutter in dim rooms. Roborock spent its budget on lift: 18,500 Pa of suction, hot-water mop washing, and larger dock reservoirs. They land close in price, close in overall rating, and share most of the smart-home basics. So the real question is whether your floors need more muscle or more awareness.
eufy X10 Pro Omni
out of 10Roborock Qrevo S Pro
The X10 Pro Omni takes the overall rating 7.2 versus 6.8, and almost all of that comes from navigation at 8.3 versus 7.0. Cleaning is a dead heat at 7.0 for both, and features sit nearly level at 6.2 versus 6.1. Both land in fair territory on value. That pattern is easy to read: the eufy sees obstacles better, the Roborock hits harder, and neither one runs away with the matchup. Preference decides this one.
Start with suction, since it's the widest gap here: 18,500 Pa on the Qrevo S Pro against 8,000 Pa on the X10 Pro Omni. That's more than double, and it shows up most on medium and high-pile carpet. Obstacle handling flips the story. The eufy uses an RGB camera paired with an LED light, so it recognizes what's on the floor and works in the dark, whereas the Roborock relies on 3D structured light. Dock behavior differs too: the Qrevo S Pro washes its mop pads with 167 °F water and holds more clean water, dirty water, and dust in the dock. Mapping favors eufy at 5 levels to 4, and the eufy lifts its mops 12 mm versus 10 mm when it hits carpet.
At 18,500 Pa, the Qrevo S Pro has well over double the rated suction of the X10 Pro Omni's 8,000 Pa, which matters most for debris buried in carpet pile. The eufy's single brush mixes rubber and bristle, a combo that grabs fine dust well on hard floors, but it doesn't close the suction gap.
Both use dual spinning mop pads, the most effective mainstream mopping setup, and they spin at similar speeds (180 RPM for eufy, 200 RPM for Roborock). The eufy presses down with 9.8 N and lifts its pads 12 mm over carpet versus 10 mm; the Roborock counters with far more granular water control across 30 moisture levels compared to 3.
Heavy shedders favor the Roborock here, since 18,500 Pa pulls embedded hair out of rugs and upholstery-height carpet more reliably than 8,000 Pa. Its dock dust bag is a bit larger too, so you'll swap bags slightly less often.
The X10 Pro Omni adds an RGB camera and an LED light on top of LiDAR, so it identifies specific objects and keeps working in unlit rooms, where the Roborock's 3D structured light handles shapes without that visual context. eufy also stores maps for up to 5 floors versus 4 and clears 21 mm thresholds against 20 mm.
Roborock's dock washes the mop pads with 167 °F water, which breaks down greasy residue far better than a cold rinse, and it holds more clean water, more dirty water, and more dust. Both docks empty the robot's bin automatically, so the difference is refill and wash quality rather than basic automation.
Runtimes sit close at 173 minutes for the eufy and 180 for the Roborock. eufy publishes a 1,615 sq ft single-run coverage figure, which is enough for most whole-floor cleans before it heads back to recharge.
Both cover the essentials: voice control, no-go zones, multi-level maps, smart carpet cleaning, and smart obstacle avoidance. The Roborock adds Apple to its Amazon and Google voice support, so Siri households get an extra option.
| Feature | eufy X10 Pro Omni | Roborock Qrevo S Pro |
|---|---|---|
| Suction Power | 8,000 Pa | 18,500 Pa |
| Main Brush Type | Single (rubber & bristle) | Single (rubber) |
| Camera | Yes | No |
| Mop Moisture Levels | 3 | 30 |
| Mop Auto-Washing Temperature | 0 °F | 167 °F |
| Light | Yes | No |
We may earn a commission if you make a purchase
These two land close enough that neither is a mistake. Pick the eufy X10 Pro Omni if cluttered, dimly lit floors are your reality and you want a robot that navigates them thoughtfully. Pick the Qrevo S Pro if carpet, pet hair, and greasy hard floors are the problem you're actually solving.
